| ( 4 ) | Make the tray.
The tray is made in two pieces with the wire mesh sandwiched between. I found the extra support (front to back) on the underneath layer was necessary to prevent sagging.
|
| ( 4 ) | Make the tray.
The tray is made in two pieces with the wire mesh sandwiched between. I found the extra support (front to back) on the underneath layer was necessary to prevent sagging.
|
| ( 5 ) | Make the slider
This is a simple frame with wire mesh on the bottom. I found that a nailing strip (S3-S4) was necessary to prevent raw ends of the mesh catching.
|
